Agilent Technologies 35670A Installation Manual page 65

Agilent 35670A
3
Press the following keys and type in the printer address when the program prompts
you:
[
[
[
[
[
[
4
Press the following keys to start the test:
[
[
When you select [
printed only after all tests are done. When you select [
[
5
Follow the directions on the display.
During the test, the program prompts you to change the test equipment
Warning
connections. Always turn the ac calibrator output to OFF or STANDBY before
changing test equipment connections. The ac calibrator can produce output
voltages that could result in injury or death to personnel.
The directions on the display briefly tell you how to connect test equipment. For
detailed illustrations of equipment setup, see the setup illustrations starting on page
3-13.
If you want to pause the program and return the Agilent 35670A Dynamic Signal
Analyzer to front panel control, press [
[
any instrument setup states, press [
ensure accurate measurement results.
]
TEST CONFIG
]
PRINTER ADDRESS
]
PROCEDURE
] or [
OP_VERIFY PERFORMAN
[ ]
STOP AFTER
] or [
LIMIT FAILURE NONE
]
RETURN
]
START TESTING
]
START BEGINNING
START BEGINNING
], the data is printed immediately after each measurement.
ONE TEST
] [
BASIC DISPLAY SETUP
To run the program in semiautomated mode
]
]
], the data is written to a file on the disk and
]. To continue the program, press
BASIC
] [ ] [
LOWER RETURN
] instead of [
RESTART TEST
Verifying Specifications
] or
START MIDDLE
] [ ]. If you changed
CONTINUE
CONTINUE
]to
3-9