Incoming Inspection; Serial Numbers; Recording The Device Serial Numbers - Agilent Technologies 85050B User's And Service Manual

General Information

Incoming Inspection

Incoming Inspection
Refer to "Kit Contents" on page 1-2
the serial numbers of all serialized devices in your kit.
Check for damage. The foam-lined storage case provides protection during shipping. If the
case or any device appears damaged, or if the shipment is incomplete, refer to
Agilent" on page 5-4. Agilent will arrange for repair or replacement of incomplete or
damaged shipments without waiting for a settlement from the transportation company.
See "Returning a Kit or Device to Agilent" on page

Serial Numbers

A serial number is attached to this calibration kit. The first four digits followed by a letter
comprise the serial number prefix; the last five digits are the suffix, unique to each
calibration kit.

Recording the Device Serial Numbers

In addition to the kit serial number, the devices in the kit are individually serialized (serial
numbers are labeled onto the body of each device). Record these serial numbers in
Table 1-1. Recording the serial numbers will prevent confusing the devices in this kit with
similar devices from other kits.
Table 1-1 Serial Number Record for the 85050B
Device
Calibration kit
Broadband load
Lowband load
Open
Short
Sliding load
Connector gage
Gage master
1- 4
to verify a complete shipment. Use
5-3.
Serial Number
_______________________________
_______________________________
_______________________________
_______________________________
_______________________________
_______________________________
_______________________________
_______________________________
Table 1-1 to record
"Contacting
85050B