To Connect The Analyzer To A Serial Device; To Connect The Analyzer To A Parallel Device - Agilent Technologies 35670A Installation Manual
Hide thumbs
Also See for 35670A:
- Manual (796 pages) ,
- Service manual (439 pages) ,
- Operator's manual (322 pages)
Table of Contents
Advertisement
Agilent 35670A
To connect the analyzer to a serial device
The Serial Port is a 9-pin, EIA-574 port that is only available using Instrument Basic.
The total allowable transmission path length is 50 feet.
•
Connect the analyzer's rear panel SERIAL PORT to a serial device using a 9-pin
female to 25-pin RS-232-C cable.
Part Number
HP 24542G
HP 24542H
For additional information, see chapter 9 in the Agilent 35670A Service Guide.
To connect the analyzer to a parallel device
The Parallel Port is a 25-pin, Centronics port. The Parallel Port can interface with
PCL printers or HP-GL plotters.
•
Connect the analyzer's rear panel PARALLEL PORT connector to a plotter or printer
using a Centronics interface cable.
For additional information, see chapter 9 in the Agilent 35670A Service Guide.
To connect the analyzer to a serial device
Cable Description
9-pin female to 25-pin male RS-232
9-pin female to 25-pin female RS-232
Preparing the Analyzer for Use
2-11
Advertisement
Table of Contents
