Interpreting Panel Displays; Panel Displays - YASKAWA SGD7S Product Manual

1.5 Interpreting Panel Displays

1.5.1 Panel Displays

1.5

Interpreting Panel Displays

1.5.1

Panel Displays

You can check the Servo Drive status on the panel display of the SERVOPACK.
Also, if an alarm or warning occurs, the alarm or warning number will be displayed.
Interpreting Status Displays
The status is displayed as described below.
Display
Alarm and Warning Displays
If there is an alarm or warning, the display will change in the following order.
Example: Alarm A.020
Status Display
Hard Wire Base Block Active Display
If a hard wire base block (HWBB) is active, the display will change in the following order.
Status Display
Overtravel Display
If overtravel has occurred, the display will change in the following order.

CCW Overtravel (CCW-OT)
Status Display
1-8
Meaning
Rotation Detection Display
Lit if the Servomotor speed is higher than the
setting of Pn502 or Pn581 and not lit if the
speed is lower than the setting. (The default set-
-1
ting is 20 min or 20 mm/s.)
Base Block Display
Lit during the base block state (servo OFF). Not
lit while the servo is ON.
Not lit. Not lit.
Not lit. Not lit.

CW Overtravel (CW-OT)
Status Display
Display
Reference Input Display
Lit while a reference is being input.
Connected Display
Lit while there is a connection.
Not lit. Not lit.
Not lit. Not lit.

CCW and CW Overtravel
Status Display
Meaning
Not lit.