Resetting Alarms - YASKAWA SGD7S Product Manual

14.2.3

Resetting Alarms

If there is an ALM (Servo Alarm) signal, use one of the following methods to reset the alarm
after eliminating the cause of the alarm.
Be sure to eliminate the cause of an alarm before you reset the alarm.
If you reset the alarm and continue operation without eliminating the cause of the alarm, it may
result in damage to the equipment or fire.
Important
Resetting Alarms with I/O Communications
Refer to the following section for details on resetting alarms with I/O communications.
13.2.1
I/O Communications
Resetting Alarms Using the Digital Operator
Press the ALARM RESET Key on the Digital Operator. Refer to the following manual for details
on resetting alarms.
Σ-7-Series Digital Operator Operating Manual (Manual No.: SIEP S800001 33)
on page 13-5
14.2 Alarm Displays
14.2.3 Resetting Alarms
14-43
14