Preparations; Applicable Tools; Operating Procedure - YASKAWA SGD7S Product Manual

8.10.2

Preparations

Always check the following before you execute vibration suppression.
• The tuning-less function must be disabled (Pn170 = n.0).
• The test without a motor function must be disabled (Pn00C = n.0).
• The parameters must not be write prohibited.
8.10.3

Applicable Tools

The following table lists the tools that you can use to perform vibration suppression and the
applicable tool functions.
Tool
Digital Operator
SigmaWin+
8.10.4

Operating Procedure

Use the following procedure to perform vibration suppression.
1.
Perform steps 1 to 8 of the procedure for custom tuning. Refer to the following section
for details.
8.8.4 Operating Procedure on page 8-43
2.
Click the Vib Suppress Button.
3.
Click the Import Button or click
When you click the Import Button, the residual vibration frequency in the Servomotor is read as the
set frequency. (The frequency can be read only when the residual vibration frequency is between 1.0
and 100.0.)
Frequency detection will not be performed if there is no vibration or if the vibration frequency
is outside the range of detectable frequencies. If a vibration frequency is not detected, pro-
vide a means of measuring the vibration frequency.
Important
Function
Fn205
Tuning - Tuning
and
Operating Procedure Reference
Σ-7-Series Digital Operator Operating Man-
ual (Manual No.: SIEP S800001 33)
8.10.4 Operating Procedure on page 8-57
Button to manually adjust the set frequency.
8.10 Vibration Suppression

8.10.2 Preparations

8
8-57