1
First Steps with the TNC 320
1.4
Graphically testing the first part
Starting the test run
Press the RESET + START soft key: The TNC
simulates the active program up to a programmed
break or to the program end
While the simulation is running, you can use the
soft keys to change views
Press the STOP soft key: The TNC interrupts the
test run
Press the START soft key: The TNC resumes the
test run after a break
Further information on this topic
Running a test run: See "Test Run", page 449
Graphic functions: See "Graphics ", page 438
Adjusting the test speed: See "Speed of the Setting test runs",
page 439
54
TNC 320 | User's Manual HEIDENHAIN Conversational Programming | 5/2013