Program Run - HEIDENHAIN TNC 320 User Manual

Conversational programming

Hide thumbs Also See for TNC 320:

Table of Contents

Test run and program run

14.5 Program run

In the Program Run, Full Sequence mode of operation the TNC

executes a part program continuously to its end or up to a program

In the Program Run, Single Block mode of operation you must start

each block separately by pressing the machine START button.

The following TNC functions are available in the program run

modes of operation:

Interrupt program run

Starting the program run from a certain block

Optional block skip

Editing the tool table TOOL.T

Checking and changing Q parameters

Superimposing handwheel positioning

Functions for graphic simulation

Additional status display

TNC 320 | User's Manual HEIDENHAIN Conversational Programming | 5/2013