Function Paraxmode Off - HEIDENHAIN TNC 320 User Manual

10
Programming: Special functions
10.2 Working with the Parallel Axes U, V and W
Move the principal axis and the parallel axis simultaneously
If the PARAXMODE function is active, the TNC uses the axes defined
in the function to execute the programmed traverse movements.
If the TNC is to traverse a parallel axis simultaneously with the
associated principal axis, you can identify the respective axis by
additionally entering the character "&". The axis with the & character
then refers to the principal axis.
The syntax element "&" is only permitted in L blocks.
Additional positioning of a principal axis with the "&"
command is done in the REF system. If you have set
the position display to "actual value", this movement
will not be shown. If necessary, switch the position
display to "REF value".

FUNCTION PARAXMODE OFF

Use the PARAXCOMP OFF function to switch off the parallel-axis
function. The TNC then uses the principal axes defined by the
machine manufacturer. Proceed as follows for the definition:
Show the soft-key row with special functions
Select the menu for defining various plain-language
functions
Select FUNCTION PARAX
Select FUNCTION PARAXMODE
Select FUNCTION PARAXMODE OFF
332
TNC 320 | User's Manual HEIDENHAIN Conversational Programming | 5/2013
NC block
13 FUNCTION PARAXMODE X Y W
14 L Z+100 &Z+150 R0 FMAX
NC block
13 FUNCTION PARAXCOMP OFF