HEIDENHAIN TNC 320 User Manual page 528

16
Tables and overviews
16.5 Functions of the TNC 320 and the iTNC 530 compared
Comparison: Differences in Test Run, functionality
Function
Test Run up to block N
Calculation of machining time
Comparison: Differences in Test Run, operation
Function
Arrangement of soft-key rows and
soft keys within the rows
Zoom function
Machine-specific miscellaneous
functions M
Displaying/editing the tool table
Comparison: Differences in Manual Operation,
functionality
Function
Manual probing cycles in the tilted
working plane (3DROT: Active)
Jog increment function
528
TNC 320
Function not available
Each time the simulation is
repeated by pressing the START
soft key, the machining time is
totaled
TNC 320
Arrangement of soft-key rows and soft-keys varies depending on the
active screen layout.
Each sectional plane can be
selected by individual soft keys
Lead to error messages if they
are not integrated in the PLC
Function available via soft key
TNC 320
Manual probing cycles in the
tilted working plane can only be
used if 3D-ROT for Manual
Automatic operating modes is
set to "Active".
The jog increment can be defined
separately for linear and rotary
axes
TNC 320 | User's Manual HEIDENHAIN Conversational Programming | 5/2013
iTNC 530
Function available
Each time the simulation is
repeated by pressing the START
soft key, time calculation starts at
0
iTNC 530
Sectional plane can be selected
via three toggle soft keys
Are ignored during Test Run
Function not available
iTNC 530
Manual probing cycles in the tilted
working plane can only be used
and if 3D-ROT for Manual
mode is set to "Active".
The jog increment applies for both
linear and rotary axes
operating