HEIDENHAIN TNC 320 User Manual page 31

11 Programming: Multiple Axis Machining...................................................................................... 347
11.1 Functions for multiple axis machining.............................................................................................. 348
11.2 The PLANE Function: Tilting the Working Plane (Software Option 1)............................................349
Introduction.............................................................................................................................................349
Defining the PLANE function.................................................................................................................351
Position display.......................................................................................................................................351
Resetting the PLANE function............................................................................................................... 352
Defining the working plane with the spatial angle: PLANE SPATIAL.................................................... 353
Defining the working plane with the projection angle: PLANE PROJECTED........................................ 355
Defining the working plane with the Euler angle: PLANE EULER.........................................................356
Defining the working plane with two vectors: PLANE VECTOR........................................................... 358
Defining the working plane via three points: PLANE POINTS...............................................................360
Defining the working plane via a single incremental spatial angle: PLANE SPATIAL.............................362
Tilting the working plane through axis angle: PLANE AXIAL (FCL 3 function)...................................... 363
Specifying the positioning behavior of the PLANE function.................................................................. 365
11.3 Miscellaneous functions for rotary axes........................................................................................... 370
Feed rate in mm/min on rotary axes A, B, C: M116 (software option 1)............................................... 370
Shortest-path traverse of rotary axes: M126.........................................................................................371
Reducing display of a rotary axis to a value less than 360°: M94.........................................................372
Selecting tilting axes: M138...................................................................................................................373
TNC 320 | User's Manual HEIDENHAIN Conversational Programming | 5/2013
31