1
First Steps with the TNC 620
1.4
Graphically testing the first part (Advanced Graphic Features
software option)
Starting the test run
Press the RESET + START soft key: The TNC
simulates the active program up to a programmed
break or to the program end
While the simulation is running, you can use the
soft keys to change views
Press the STOP soft key: The TNC interrupts the
test run
Press the START soft key: The TNC resumes the
test run after a break
Further information on this topic
Running a test run: See "Test Run", page 477
Graphic functions: See "Graphics (Advanced Graphic Features
software option)", page 466
Adjusting the test speed: See "Speed of the Setting test runs",
page 467
58
TNC 620 | User's Manual
HEIDENHAIN Conversational Programming | 5/2013