HEIDENHAIN TNC 320 User Manual page 462

Conversational programming

Hide thumbs Also See for TNC 320:

Table of Contents

Test run and program run

14.8 Optional program-run interruption

Optional program-run interruption

The TNC optionally interrupts program run at blocks containing M1.

If you use M1 in the Program Run mode, the TNC does not switch

off the spindle or coolant.

Do not interrupt program run or test run at blocks

containing M1: Set soft key to OFF

Interrupt program run or test run at blocks

containing M1: Set soft key to ON

TNC 320 | User's Manual HEIDENHAIN Conversational Programming | 5/2013