HEIDENHAIN TNC 320 User Manual page 148

Conversational programming

Hide thumbs Also See for TNC 320:

Table of Contents

Programming: Tools

Edit the tool table

The tool table that is active during execution of the part program is

designated TOOL.T and must be saved in the TNC:\table directory.

Other tool tables that are to be archived or used for test runs are

given any other names with the extension T. By default, for Test

Run and Programming modes the TNC uses the "simtool.t" table,

which is also stored in the "table" directory. In the Test Run mode,

press the TOOL TABLE soft key to edit it.

To open the tool table TOOL.T:

Select any machine operating mode

Select the tool table: Press the TOOL TABLE soft

Set the EDIT soft key to ON

Displaying only specific tool types (filter setting)

Press the TABLE FILTER soft key (fourth soft-key row)

Select the tool type by pressing a soft key: The TNC only shows

tools of the type selected

Cancel filter: Press the previously selected tool type again or

select another tool type

The machine tool builder adapts the features of the

filter function to the requirements of your machine.

Refer to your machine manual.

TNC 320 | User's Manual HEIDENHAIN Conversational Programming | 5/2013