HEIDENHAIN TNC 320 User Manual page 534

16
Tables and overviews
16.5 Functions of the TNC 320 and the iTNC 530 compared
Function
SLII Cycles 20 to 24:
Handling of islands which are
not contained in pockets
Set operations for SL cycles
with complex contour formulas
Radius compensation is active
during CYCL CALL
Paraxial positioning blocks in
contour subprogram
Miscellaneous functions M in
contour subprogram
M110 (feed-rate reduction for
inside corner)
SLII Contour Train Cycle 25:
APPR/DEP blocks in contour
definition
General cylinder surface
machining:
Contour definition
Offset definition on cylinder
surface
Offset definition for basic
rotation
Circle programming with C/CC
APPR/DEP blocks in contour
definition
Cylinder surface machining
Cycle 28:
Complete roughing-out of slot
Definable tolerance
Cylinder surface machining
Cycle 29
Cycles 25x for pockets, studs
and slots:
Plunging movements
534
TNC 320
Cannot be defined with
complex contour formula
Real set operation possible
Error message is issued
Error message is issued
Error message is issued
Function does not work within
SL cycles
Not allowed, machining of closed
contours is more coherent
With X/Y coordinates,
independent of machine type
With datum shift in X/Y,
independent of machine type
Function available
Function available
Function not available
with
Function available
Function available
with Direct plunging to contour of
ridge
In limit ranges (geometrical
conditions of tool/contour)
error messages are triggered
if plunging movements lead to
unreasonable/critical behavior
TNC 320 | User's Manual HEIDENHAIN Conversational Programming | 5/2013
iTNC 530
Restricted definition in complex
contour formula is possible
Only restricted performance of
real set operation possible
Radius compensation is
canceled, program is executed
Program is executed
M functions are ignored
Function also works within SL
cycles
APPR/DEP blocks are allowed as
contour elements
Machine-dependent, with
existing rotary axes
Machine-dependent datum
shift in rotary axes
Function not available
Function not available
Function available
Function not available
Function available
Circular approach to contour of
ridge
In limit ranges (geometrical
conditions of tool/contour),
vertical plunging is used if
required