HEIDENHAIN TNC 320 User Manual page 478

15
MOD functions
15.9 Ethernet interface
Configuring the control's network address
Connect the TNC (port X26) with a network or a PC
In the file manager (PGM MGT), select the Network soft key
Press the MOD key. Then enter the code number NET123.
Press the CONFIGURE NETWORK soft key to enter the network
setting for a specific device (see figure at center right)
The dialog window for the network configuration opens
Setting
HOSTNAME
DHCP
IP ADDRESS
SUBNET
MASK
478
Meaning
Name under which the control logs onto
the network. If you use a host-name server,
you must enter the "Fully Qualified Host
Name" here. If you do not enter a name
here, the control uses the so-called null
authentication.
DHCP = Dynamic Host Configuration
Protocol. In the drop-down menu, set YES.
Then the control automatically draws its
network address (IP address), subnet mask,
default router and any broadcast address
from a DHCP server in the network. The
DHCP server identifies the control by its
host name. Your company network must be
specially prepared for this function. Contact
your network administrator.
Network address of the control: In each
of the four adjacent input fields you can
enter three digits of the IP address. To move
to the next field, press the ENT key. Your
network specialist can give you a network
address for the control.
Serves to differentiate between the network
ID and the host ID of the network: Your
network specialist assigns the subnet mask
of the control.
TNC 320 | User's Manual HEIDENHAIN Conversational Programming | 5/2013