L2Protocol-Tunnel Cos - Cisco ME 3400 Command Reference Manual

l2protocol-tunnel cos

l2protocol-tunnel cos
Use the l2protocol-tunnel cos global configuration command to configure class of service (CoS) value
for all tunneled Layer 2 protocol packets. Use the no form of this command to return to the default
setting.
This command is supported only when the switch is running the metro access or metro IP access image.
Syntax Description
value
Defaults
The default is to use the CoS value configured for data on the interface. If no CoS value is configured,
the default is 5 for all tunneled Layer 2 protocol packets.
Command Modes
Global configuration
Command History Release
12.2(25)EX
Usage Guidelines
When enabled, the tunneled Layer 2 protocol packets use this CoS value.
The value is saved in NVRAM.
Examples
This example shows how to configure a Layer-2 protocol-tunnel CoS value of 7:
Switch(config)# l2protocol-tunnel cos 7
Related Commands Command
show l2protocol-tunnel
Cisco ME 3400 Ethernet Access Switch Command Reference
2-196
l2protocol-tunnel cos value
no l2protocol-tunnel cos
Specify CoS priority value for tunneled Layer 2 protocol packets. If a CoS
value is configured for data packets for the interface, the default is to use
this CoS value. If no CoS value is configured for the interface, the default is
5. The range is 0 to 7, with 7 being the highest priority.
Modification
This command was introduced.
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
Description
Displays information about ports configured for Layer 2 protocol
tunneling, including CoS.
OL-9640-07