Siemens SIMOCODE pro Operating Manual page 65

● Additional fault information for the "Positioner" or "Solenoid valve" control function:
– Stalled positioner: The torque switch has been activated before the corresponding limit
– Double 0: Both torque switches have responded ("positioner" control function only)
– Double 1: Both limit switches have responded.
– End position: Positioner or valve has left the end position without receiving a control
– Antivalence: The changeover contacts of the limit switches do not issue an antivalent
Figure 4-11
SIMOCODE pro - Parameterize
Operating Manual, 04/2017, A5E40507630002A/RS-AA/001
switch. The positioner may have stalled.
command
signal ("Positioner 5" control function only).
"Extended control" function block
Parameters
4.2 Motor control
65