Siemens SIMOCODE pro Operating Manual page 211

Special reset options:
A specific reset input is also available in addition to the other reset options (remote reset,
Test / Reset buttons, OFF command reset). Furthermore, Auto-Reset can also be activated.
See table below.
Settings
Table 4- 72 "External Fault" settings
External fault 1 to 6
Input
Type
Active status
Response
Reset
Reset also by
Marking
1)
Note
Changing the marking of all Ethernet and PROFINET connections
Each change to the marking requires that the communication interface be restarted when the
web server is active.
A new start interrupts all Ethernet and PROFINET links and reestablishes them afterward.
SIMOCODE pro - Parameterize
Operating Manual, 04/2017, A5E40507630002A/RS-AA/001
Description
Activation of the "External Fault" function block by the monitored signal (any sockets, e.g. device
inputs, communication bus control bits, etc.)
Specification of the input logic:
NO contact (1-active) (default)
•
NC contact (0-active)
•
Specify in which motor operating state the external fault is to be evaluated:
Always (default): Always evaluate, regardless of whether the motor is running or at a standstill
•
Only when motor on: Evaluation only if motor is switched ON.
•
Specification of the response to an external fault when activated via the input (see the following
table and Chapter Important information (Page 7)).
Acknowledge the "External fault" fault via any signal (any sockets, e.g. device inputs,
communication bus control bits, etc.)
Specification of further (common) acknowledgement options using additional reset types:
Test/Reset buttons on the basic unit and the operator panel or, in the case of the operator
•
panel with display, via the menu (panel reset) (default)
Remote reset: Acknowledgment via reset 1 to 3, DPV1, "Reset" command (default)
•
Auto reset: The fault resets itself after the cause has been eliminated (after removal of the
•
activation signal)
OFF command reset: "OFF" control command, resets the fault
•
No parameters. Optional marking for designating the event, e.g. "Speed >," e.g. with
SIMOCODE ES. Range: maximum 10 characters.
Parameters
4.7 Standard functions
211