Siemens SIMOCODE pro Operating Manual page 54

Parameters
4.2 Motor control
● PC or PC/OPC UA [HMI] control station: This control station is primarily intended for
switching commands on an arbitrary PC that, along with the automation system, is used
as a second master on PROFIBUS DP or that, as a client, accesses the data made
available by SIMOCODE pro, as server, via OPC UA. The control commands are sent via
the Acyclic receive telegram from PROFIBUS DPV1 or are transferred using a client-
server connection via OPC UA.
Note
If the SIMOCODE ES or SIMATIC PDM PC software is connected to SIMOCODE pro via
communication bus, its control commands automatically take effect via the PC [DPV1] or
"PC PC/OPC UA" control station. At the same time, the enabled commands for this
control station also take effect for SIMOCODE ES.
54
SIMOCODE pro - Parameterize
Operating Manual, 04/2017, A5E40507630002A/RS-AA/001