Siemens SIMOCODE pro Operating Manual page 13

The following table shows the possible output types of the internal function blocks of
SIMOCODE pro:
Table 2- 2 Output types of the internal function blocks of SIMOCODE pro
Output
Sockets (binary)
Sockets (analog)
Screw terminals
Message data to the
communication bus
Binary terminal block
Analog terminal block
SIMOCODE pro - Parameterize
Operating Manual, 04/2017, A5E40507630002A/RS-AA/001
Example
Function blocks in the basic units may have binary sockets. These sockets are assigned to
binary plugs in the software. They are relevant for parameterization, e.g. with SIMOCODE ES.
Function blocks in the basic units may have analog sockets. These sockets are assigned to
analog plugs in the software. They are relevant for parameterization, e.g. with SIMOCODE ES.
Example: 2-byte word, max. current I_max.
Screw terminals are outside, e.g. "BU Output" function block. The contactors, for example, are
connected here.
e. g from SIMOCODE pro to the DP master
Internal binary signals (binary sockets) that are not assigned to a function block (fault, status,
other), e.g. "Status - Device o. k. (in the CFC editor)
Internal analog signals (analog sockets) that are not assigned to a function block, e.g. "Phase
Unbalance" (in the CFC editor).
2.1 Function blocks - input and output types, structure
Function blocks
13