Ricoh MP C4503 Technical Bulletin page 78

Reissued: 26-Dec-16
Model:
MET-C1ab_SOP
Version
4.
5.
6.
7.
8.
9.
10. It takes a long time (151 sec.) to access SP mode from the time the main power is
11. The multi-feed detection setting (enable/disable in SP mode) for the bypass tray is
12. SC997 may occur when the machine main power is turned ON.
13. SC816-38 occurs when the machine enters Energy Saver mode, followed by SC819.
14. The IP address/MAC address appears as "0.0.0.0." on the System Settings List for
Other changes:
1.
2.
3.
2.25 Symptom corrected:
1.
2.
3.
4.
5.
6.
T
echnical
Modified Points or Symptom Corrected
completely booted up.
The message displayed in WIM when the paper is loaded incorrectly was changed
as follows:
Before: "Reduce paper in the tray(s) to the limit mark and reset it correctly."
After: "Reduce paper in the tray(s) to the limit mark or reset it correctly."
The printing speed becomes slow or the connection between the machine and Fiery
controller fails when the two are connected.
SC899 occurs and the machine stalls.
In the "Extended Feature Settings" in Web Image Monitor, when overwriting Type-J
applications that were already installed on the hard drive, the applications might not
automatically start even if the Auto Start is set to "On".
When the following settings are configured in the Scanner Features and the device
is restarted, the scanner might not start:
- Either "Title2" or "Title3" in "Switch Title" is selected.
- "DSM" in "Use WSD or DSM" is selected.
- "Not Available" in "Use a Destination List that is not DSM" is selected.
When "OCR Settings" is set to "On", if the keywords in a PDF file are scanned by
selecting a language other than "Japanese" in the "Cognitive Language" setting, the
position of the search results might be incorrect.
This firmware is dependent on Scanner firmware v02.15(D1465560E) or later, so
please be sure to update it.
turned ON (this time was reduced to 46 sec.).
mistakenly applied to the LCT, and vice-versa.
the Printer.
The illustrations used in the animated instructions for clearing original jams were
made easier to understand.
Support for displaying the estimated time to obtain logs that are stored by using the
log-storing function.
Support for using the rear SD card slot to obtain logs that are stored on the device by
using the log-storing function.
"Replace controller board" appears on the operation panel when the machine boots
up or recovers from Energy Saver mode.
A blank sheet is printed out when scanning mixed-sized originals using
reduction/enlargement (and can only be cleared by power OFF/ON).
The incorrect name of a supply product is displayed if the stapler is empty when the
SR3150 Booklet Finisher is installed.
The machine takes a long time to recover from Energy Saver mode if prompted by
an IC card, or takes a long time to complete login with an IC card.
Black bands appear on the trailing edge of an image that is scanned and then
forwarded.
The icon for an SDK application disappears when the machine recovers from Energy
Saver mode if the machine entered the mode after the SDK was booted up.
B
ulletin
Date:
01-Aug-13
PAGE: 9/11
No
RD147031y
.: