Ricoh MP C4503 Technical Bulletin page 30

Reissued: 22-Dec-16
Model:
MET-C1ab
Version
12.70.4 Other changes:
Supports IPv6/DNS for @Remote.
IMPORTANT: To apply the above change, in addition to this firmware, make sure to
update the System/Copy firmware to Ver.1.08 or later.
12.70.3 Symptom corrected:
1. When simultaneously printing from AppleTalk on a Mac and a protocol other than
AppleTalk in Windows, an SC899 error might occur.
2. When PEAP or TTLS is used as the IEEE 802.1X authentication method and the
server certification check is disabled, the IP address might not be obtained after the
device is restarted.
12.70.2 Symptom Corrected:
[Embedded RC Gate]: "@Remote certificate updating..." is displayed and @Remote
communication is suspended if SSL communication with a router or proxy server was
suspended due to no response or detection of RESET signal.
Note: A certificate update indicates that a request to update the certificate was sent to the
@Remote Center instead of performing the retry process.
This firmware correction is dependent on the following firmware modules.
Please be sure to update it:
System/Copy firmware v1.05 or later
12.70.1 Symptom corrected:
SC991 may be logged on the SMC report when the main power switch is turned on.
When DHCP v6 is enabled, turning the power off and then on might cause a memory leak.
12.68 1st Mass production
T B
echnical
Modified Points or Symptom Corrected
ulletin
Date:
18-Jun-13
PAGE: 3/3
No
RD147009o
.: