Ricoh MP C4503 Technical Bulletin page 62

Model:
MET-C1
IMPORTANT:
If you wish to merge multiple applications onto a single SD card, do the merge
now before moving onto the next step.
4. Insert the power cord into the outlet, and then turn on the main power switch.
5. Access System/Copy SP mode.
6. Do this step only if you are installing the option on a machine that is already in use (not a new
machine):

If the customer wishes to continue using the same hard disk:
Execute all three SP modes below.
SP5-801-014 (Clear DCS Setting)
SP5-832-001 (HDD Formatting (ALL))
SP5-832-002 (HDD Formatting (IMH))

If customer wishes to replace the hard disk with a new one:
Execute SP5-801-014 only.
Note: If the customer continues using the same hard disk, the overwriting of the data stored on
the disk before the option is installed cannot be guaranteed. It is highly recommended to
replace the hard disk with a new one.
7. Set SP5-836-001 (Capture Function (0:Off 1:On)) to a value of 0 (disable).
8. Execute SP5-878-001 ([Option Setup：Data Overwrite Security).
Note: If the installation fails, "Installation failed" is displayed when this SP is
executed.
9. Print out the System Settings List and make sure that the option was installed successfully.
10. Turn off the machine main power switch.
11. Reattach the cover for the SD card slot.
12. Reconnect the network cable.
13. Insert the power cord into the outlet and turn on the main power switch.
14. Execute SP5-990-005 (SP print mode Diagnostic Report).
15. Make sure that ROM number "D3775912B" and firmware version "1.02m" appear in both of the
following areas on the report (they must match):
"ROM Number / Firmware Version" – "HDD Format Option"
"Loading Program"
T B
echnical ulletin
Date:
20-Jun-13
PAGE: 3/5
No
.: RD147028