Ricoh MP C4503 Technical Bulletin page 413

Model:
MET-C1b
restoring. This is because there is a risk that the data cannot be backed up properly
depending on the NV-RAM condition.
STEPS 7-10: Additional steps ONLY for machines that have the FAX installed.
7. Print the Box List by pressing these buttons in the following order: [Facsimile Features] -
[General Setting] - [Box Setting: Print List]
8. Print the Special Sender List by pressing these buttons in the following order: [Facsimile
Features] - [Reception] - [Program Special Sender: Print List]
9. Write down the following fax settings.
 [Receiver] in [Facsimile Features] - [Reception] - [Reception File Settings] - [Forwarding].
 [Notify Destination] in [Facsimile Features] - [Reception] - [Reception File Settings] -
[Store].
 [Specify User] in [Facsimile Features] - [Reception] - [Stored Reception File User Setting].
 [Notify Destination] in [Facsimile Features] - [Reception] - [Folder Transfer Result Report].
 Specified folder in [Facsimile Features] - [Send] - [Backup File TX Setting].
 [Receiver] in [Facsimile Features] - [Reception] - [Reception File Settings] - [Output Mode
Switch Timer].
 [Store: Notify Destination] in [Facsimile Features] - [Reception] - [Output Mode Switch
Timer].
 All the destination information shown on the display.
Note:
 In the fax settings, address book data is stored with entry IDs, which the system
internally assigns to each data. The entry IDs may be changed due to re-assigning in
backup/restore operations.
10. Make sure that there is no transmission standby file. If any standby file exists, ask the
customer to delete it or complete the transmission.
11. Turn the power OFF and unplug the power supply cord.
12. Push the power switch ON again to discharge the residual charge.
13. Replace the NV-RAM with a brand-new one.
14. Turn the power ON with the SD card to which the NV-RAM data has been uploaded in
Slot 2.
IMPORTANT:
After turning the power ON, SC995 will be displayed in Japanese except for machines

that have a smart operation panel.
 For machines that have a smart operation panel, SC673 will occur and SC995 might be
internally issued in Japanese after turning the power ON.
 After turning the power ON, SC870 in Japanese will occur and the address book data will
be cleared.
STEP15~17: Additional procedure only for machines that have the Smart Operation Panel
installed.
Note:
 SC673 will be displayed in Japanese at start-up, but this is normal behavior. This is
because the controller and the smart operation panel cannot communicate with each other due
to changing the SP settings for the operation panel.
15. Change the SP settings for the operation panel.
 SP5-748-101: (OpePanel Setting: Op Type Action Setting): Change bit 0 from 0 to 1.
 SP5-748-201: (OpePanel Setting: Cheetah Panel Connect Setting): Change the value from
0 to 1.
16. Change the Flair API SP values.
 SP5-752-001 (Copy FlairAPIFunction Setting): Change bit 0 from 0 to 1.
echnical
T B
ulletin
Date:
12-Feb-15
PAGE: 2/5
No.:
RD147133