Juniper EX3400 Features Manual page 363

Required Privilege
Level
Related
Documentation
List of Sample Output
Output Fields
Sample Output
clear dhcp server binding <ip-address>
Copyright © 2017, Juniper Networks, Inc.
interfaces-vlan—(Optional) Clear the binding state on the interface VLAN ID and S-VLAN
ID.
interfaces-wildcard—(Optional) Clear bindings on a set of interfaces. This option supports
the use of the wildcard character (*).
logical-system logical-system-name—(Optional) Clear the binding state for DHCP
clients on the specified logical system.
routing-instance routing-instance-name—(Optional) Clear the binding state for DHCP
clients on the specified routing instance.
dual-stack—(Optional) Remove either both arms or single arm of dual-stack.
NOTE:
The
dual-stack
of the dual-stack with a single command entry.
When the
dhcpv6 server binding
the dual-stack.
view
Clearing DHCP Bindings for Subscriber Access
show dhcp server binding on page 378
clear dhcp server binding <ip-address> on page 343
clear dhcp server binding all on page 344
clear dhcp server binding interface on page 344
clear dhcp server binding <interfaces-vlan> on page 344
clear dhcp server binding <interfaces-wildcard> on page 344
clear dhcp server binding dual-stack all on page 344
See show dhcp server binding
The following sample output displays the address bindings in the DHCP client table on
the extended DHCP local server before and after the
is issued.
user@host> show dhcp server binding
Chapter 14: Operational Commands (DHCP and DHCP Relay)
command is added in the syntax removes both arms
command is not added in the syntax, the
dual-stack
command clears only the family specific arm of
for an explanation of output fields.
clear dhcp server binding
clear
command
343