show ntp
This command displays the NTP configuration and status data for Ethernet
interfaces on the IOC module. Configuration data includes state, DSCP state and
value, TTL value and VLAN ID. Status data includes state, version, mode, leap
status, stratum level, root dispersion and packet load..
Command Syntax:
To show the NTP configuration of the specified port:
show ntp config ioc-x
To show the NTP status of the specified port:
show ntp status ioc-x
Example 1:
To display NTP configuration of the port 1 Ethernet interface on the IOC module
tp5000> show ntp config ioc-1
Response 1:
NTP State
NTP DSCP
NTP DSCP State
NTP TTL
NTP VLAN Id
NTP Packet Limit
Example 2:
To display NTP status of the port 1 Ethernet interface on the IOC module
tp5000> show ntp status ioc-1
Response 2:
Port enabled:
Version:
Mode:
Leap status:
Stratum level:
Root dispersion:
Packet load:
Level :
User, Config, and Admin
098-00028-000 Revision F – May, 2012
TimeProvider 5000 CLI Command Set
enabled
0
disabled
64
2
20000
yes
4
server
no warning
1
0.0 sec
5%
TimeProvider 5000 User's Guide 177
Chapter 3