Rack Mounting The Timeprovider 5000 - Symmetricom TimeProvider 5000 User Manual

Chapter 2 Installing
Rack Mounting the Chassis
Rack Mounting the Chassis
The installation procedure described in this section provides general guidelines for
installing the TimeProvider 5000, as well as theTimeProvider E10 and TimeProvider
E30 expansion shelves. Always follow applicable local electrical standards.
Rack Mounting the TimeProvider 5000 Main Shelf
Use the following steps to mount the TimeProvider 5000 in a rack.
Note:
unoccupied for heat dissipation.
Note: The TimeProvider 5000 comes equipped with 19-inch rack
mounting brackets. 23-inch (58.42 cm) rack mounting adapters are
also available as a separately ordered item. 21-inch (ETSI) rack
mounting adapters are available as a separately ordered item.
1. TimeProvider 5000 is shipped with rack mounting brackets attached. The rack
mounting brackets can be removed and reattached in a different orientation, if
desired. See
Figure 2-6
sides are attached to the chassis at equal distances from the front of the unit (see
Figure 2-7) using 6-32 x 1/4-inch screws.
2. Mount the chassis to the front of the equipment rack rails with four screws and
associated hardware. Use the proper screws for the equipment rack.
62 TimeProvider 5000 User's Guide
1RU above the TimeProvider 5000 must be left
Figure 2-4 for mounting hole placements. See
for chassis dimensions. Ensure that the
Figure 2-5 and
on both
mounting brackets
098-00028-000 Revision F – May, 2012