Symmetricom TimeProvider 5000 User Manual page 255

upgrade
Use this command to upgrade the specified modules firmware with the specified
filename. If the IP address, username, and password is provided, the system will
FTP the filename from the specified server (IP or name) and then upgrade the
specified module.
Command Syntax:
upgrade {imc | ioc1 | ioc2 | exp[0-9]} <filepath>
[ftp: | sftp:] <ftp-ip-address> <username>
Note: The FTP firewall is set to "Block" by default. Use the following
command to set the IMC firewall to "Allow" for ftp communications:
Note: The TimeProvider 5000 only supports active FTP; it does not
support passive (PASV) mode.
Note: For SFTP, both the SFTP and SSH firewalls must be set to
"Allow". They are both set to "Allow" by default.
Note:
be included with the address.
Remarks: Firmware upgrades will not be implemented until the specified module
is rebooted.
Example 1:
To upgrade the IMC using the upgrade file path of
"/symm/tp5000/current_imc_upd", FTP server IP address 192.168.5.56, and a user
name of "bob321".
tp5000> upgrade imc /symm/tp5000/current_imc_upd
ftp:192.168.5.56 bob321
Response 1:
Password:
Upgrade of imc is in progress
098-00028-000 Revision F – May, 2012
set firewall imc ftp allow
If an SFTP server is used, the protocol does not need to
ftp:192.168.5.64
[sftp:]192.168.5.64
Chapter 3
TimeProvider 5000 CLI Command Set
TimeProvider 5000 User's Guide 255