Symmetricom TimeProvider 5000 User Manual page 157

show io-status
This command displays the system's I/O module port configuration and status. It
also displays the current SSM value for both inputs and outputs. The current SSM
value is displayed for all outputs, even if SSM is not applicable for that type of
output. If the current SSM is unknown, due to an unknown SSM code or
inappropriate frametype, then an SSM value of 15 will be displayed.
Command Syntax:
show io-status
Example:
tp5000> show io-status
Response:
------------------------------------------------------------------
|Port ID | I/O Type | Signal Type | Current Status | Current SSM |
|--------|----------|-------------|----------------|-------------|
| port1
|........|..........|.............|................|.............|
| port2
|........|..........|.............|................|.............|
| port3
|........|..........|.............|................|.............|
| port4
|........|..........|.............|................|.............|
Note: See 'show input-config' or 'show output-config' for
port configuration.
Level : User, Config, and Admin
098-00028-000 Revision F – May, 2012
| Output |T1pulse
| Input |E1/2.048MHz
| Output |1PPS
| Output |10MHz
TimeProvider 5000 CLI Command Set
| ON | 1
| OFF | 15
| ON | 15
| ON | 15
TimeProvider 5000 User's Guide 157
Chapter 3
|
|
|
|