Show Clock - Symmetricom TimeProvider 5000 User Manual

Chapter 3
TimeProvider 5000 CLI Command Set

show clock

Displays the date, time, and leapseconds in several formats.
– Current IMC time as a date and time
– Current IOC time as a date and time
– Accumulated leapseconds between TAI and UTC time
– Pending leapseconds
Command Syntax:
show clock
Example:
tp5000> show clock
Response 1:
IMC time: 2009-06-09 22:35:24
IOC time: 2009-06-09 22:35:24
Leap sec: 34
Leap pend: 0
Response 2:
When the ToD source is GPS, and the system has never been locked to GPS, the
response will be as follows:
IMC time: 2009-06-09 22:35:24 (not validated)
IOC time: 2009-06-09 22:35:24 (not validated)
Leap sec: 34
Leap pend: 0
Level : User, Config, and Admin
set clock
Provisions the user-assigned Date, Time, and accumulated leapseconds. The
reference mode must be set to the frequency mode with the
frequency
Command Syntax:
To set the Date and Time 

set clock date-time <date-time>
110 TimeProvider 5000 User's Guide
command in order to change any clock settings.
set ref mode
098-00028-000 Revision F – May, 2012