Configuration Management - Symmetricom TimeProvider 5000 User Manual

Configuration Management

The Command Line Interface (CLI), also called the ASCII command set, can be
used to control the TimeProvider 5000 from a terminal connected to the EIA-232
serial port, or the Ethernet port. Refer to
further details.
Note: Before you can communicate with the TimeProvider 5000
through an Ethernet connection, you must first configure the Ethernet
port using the serial connection (see
on page 280).
Alarms
The TP5000 uses alarms to notify you when certain conditions are deteriorating
below specified levels. Expansion shelf alarms are reported to the TP 5000 that
controls the shelf. These alarms are indicated by module status LEDs and by SNMP
traps. You can provision the alarm to either be enabled or disabled and the current
alarm state can be obtained via the communication ports. For more information, see
Provisioning
098-00028-000 Revision F – May, 2012
Alarms, on page 346 and
Chapter 3, CLI Commands and SNMP
Provisioning the Ethernet
Appendix A, System Messages.
TimeProvider 5000 User's Guide
Chapter 1 Overview
Configuration Management
for
Ports,
55