Symmetricom TimeProvider 5000 User Manual page 393

Ieee 1588 grand master clock / ntp server
Hide thumbs Also See for TimeProvider 5000:
Table of Contents

Advertisement

6. Reboot the standby IOC module by issuing the command "
the
is the standby IOC position, either 1 or 2). Immediately after the Tp5000>
x
prompt returns from this command, issue the command "
7. Allow both the standby IOC and the IMC to fully reboot and then log into the
TimeProvider 5000.
8. Issue the command "
offset fields may be incorrect - this is temporary. Please ignore this.
Issue the command "
may be alarms present that are invalid- this is temporary. Please ignore this. Wait
until the standby IOC changes from standby warm-up mode to standby.
9. Make standby IOC active with the command "
(where
x
10.Verify IOC switch state with "
the current standby IOC is running the previous firmware version with "show
inventory".
11.Reboot standby IOC with "
position, either 1 or 2). Immediately after the prompt returns, reboot IMC with
"reboot imc".
12.After the standby IOC module and IMC module return to service, log into the
TimeProvider 5000 and issue the command "show inventory". Make sure all of
the modules are now at 2.0.4 revision.
13.Issue the command "show ref". All of the input references that are not being
used must be disabled. Choose the appropriate commands from the list below for
the input references that need to be disabled:
set gnss state disable
set gps state disable
set input state port1 disable
set input state port2 disable
set pps-tod state port1 disable
set pps-tod state port2 disable
14.Verify that the TimeProvider 5000 is running correctly by issuing commands
"show status", "show alarm", and "show inventory".
098-00028-000 Revision F – May, 2012
show status
show alarm
is the standby IOC, either 1 or 2).
show ioc-state
reboot iocx
Chapter 6 Maintenance and Troubleshooting
". The current reference input and the phase
". At this point in the upgrade procedure there
set ioc-state iocx active
" CLI command. Also verify that
" (where the
is the standby IOC
x
TimeProvider 5000 User's Guide 393
Upgrading the Firmware
" (where
reboot iocx
".
reboot imc
"

Advertisement

Table of Contents
loading

Table of Contents