Management Addressing Mode - Symmetricom TimeProvider 5000 User Manual

Use the following procedure to configure Port 2 of IOC1 for Hybrid (multicast-hybrid)
PTP profile:
1. Login at the Admin or Config-user level.
2. Type
set ptp profile ioc1-2 hybrid

Management Addressing Mode

The TP5000 allows user to configure whether management messages are sent to
clients via Unicast or Multicast addresses. If the parameter is set to multicast, then
all ptp management messages directed to clients will be sent using the PTP
multicast IP address. The management addressing mode is independent of the PTP
synchronization addressing mode.
Note: The TP5000 requires a current license key to unlock the
multicast management addressing mode feature. Use the
license
Use the "set ptp mgmt-addr-mode IOC1-y { multicast
configure the TP5000 for multicast or unicast management address mode. The
default management address mode is unicast.
Only one VLAN is supported in multicast mode. See
287 for details.
Use the following procedure to configure Port 1 of IOC 1 for unicast management
address mode and Port 2 of IOC1 for multicast management addressing mode:
1. Login at the Admin or Config-user level.
2. Type
set ptp mgmt-addr-mode ioc1-1 unicast
3. Type
set ptp mgmt-addr-mode ioc1-2 multicast
098-00028-000 Revision F – May, 2012
command to display the current license.
Chapter 4 Provisioning
and press Enter.
show
unicast}" command to
|
Provisioning VLAN, on page
and press Enter.
and press Enter.
TimeProvider 5000 User's Guide 299
Provisioning PTP