8. Type
set input priority port2 6
9. Type
show ref
the desired values.
Table 4-15. Reference Modes and Priorities
Input Port
GNSS
GPS
1PPS+TOD Port 1
1PPS+TOD Port 2
E1 / T1 Port 1
E1 / T1 Port 2
Setting GPS Port as Reference
When the GPS reference is enabled, you can set the satellite position parameters
either automatically or manually. The GPS reference input is enabled by default. In
manual mode, you must specify the latitude, longitude, and height. You can also
specify the elevation mask which filters the satellites used by the system.
Note: Manual mode should not be used unless antenna location has
been accurately surveyed. See the
for details about setting GPS position parameters manually.
098-00028-000 Revision F – May, 2012
and press Enter to verify that Priority values have been set to
Reference
Card
Ref. Type
IMC
Time
IMC
Time
I/O
Time
I/O
Time
I/O
Frequency
I/O
Frequency
and press Enter.
Priority
Criteria
(Default)
Priority
1
Priority
2
Priority
3
Priority
4
Priority
7
Priority
8
set gps
command description for
TimeProvider 5000 User's Guide 313
Chapter 4 Provisioning
Provisioning the Input Reference
Predefined
PQL
Preference
(Default)
1
1
2
1
3
1
4
1
7
3
8
3