Set Grandmaster Ptp Ip Address Procedures - Symmetricom TimeProvider 5000 User Manual

Appendix F PTP Probe Option
Provisioning the Probe
Set Grandmaster PTP IP Address
To specify the Grandmaster to be used with the Probe the following parameters be
provisioned. See
Grandmaster Clock ID

Grandmaster IP Address

Grandmaster VLAN Address (if any).

Table F-8. Set Grandmaster PTP IP Address Procedures
TimeMonitor PDV
1. Click on the Command radio button to put
TimeMonitor PDV into the proper mode for
making Probe changes.
2. Click the Login button to login to the Probe,
which will prompt for Username and Password.
3. Select desired Probe port using radio buttons.
4. Enter the IP address, Netmask and Gateway
for the 1588 Master server for selected port.
5. If Master is part of a VLAN, click VLAN check
box. Enter VLAN ID in the box that appears.
6. Enter the Clock ID for the Master server.
NOTE: For a TP 5000 Grandmaster, use the show
ptp-status command to find clock ID .
7. Repeat steps 3 through 6 for the other port.
516 TimeProvider 5000 User's Guide
Table F-8 for procedures to set the Grandmaster PTP IP address:
CLI Command
Use the command:
set ptp-probe IOC1-x active-probe
gm-clock-id <clock-id> gm-ip
<addr> [vlan-id <vlan>]
where x is the port number on the IOC
Example:
For following Grandmaster specs:
Clock ID = 00:B0:AE:FF:FE:00:00:06
IP address = 192.168.1.11
VLAN ID = 35:
1. Login at the Admin or Config-user level.
2. Type set ptp-probe ioc1-1
active-probe gm-clock-id
00:B0:AE:FF:FE:00:00:06 gm-ip
192.168.1.11 vlan-id 35 and
press Enter.
3. If there is no VLAN for the
Grandmaster, type set ptp-probe
ioc1-1 active-probe
gm-clock-id
00:B0:AE:FF:FE:00:00:06 gm-ip
192.168.1.11 and press Enter.
098-00028-000 Revision F – May, 2012