Set Alarm-Config Commands; Disabling Specific Alarms - Symmetricom TimeProvider 5000 User Manual

Chapter 4 Provisioning
Provisioning Alarms
Figure 4-34. Set Alarm-Config Commands

Disabling Specific Alarms

The Set Alarm-Config command allows you to enable or disable specified alarms.
Example
To disable the GNSS/GPS antenna open-circuit alarm (alarm #13), enter the
following:
1. Login at the Admin or Config-user level (see Logging In, on page 275).
2. Type and press Enter.
set alarm-config state alarm 13 disable
Showing Current Alarm Settings
The Show Alarm-Config command displays the set and clear alarm thresholds for
every alarm type.
Example
098-00028-000 Revision F – May, 2012 TimeProvider 5000 User's Guide 347