Show Clock - Symmetricom TimeCreator 1000 User Manual

Show Clock

This command displays the system's date, time, leap seconds, and local time offset.
Command Syntax:
show clock
Example:
tc1000>show clock
Response:
Date
Time
Local Time Offset
IMC Uptime
Leap Seconds
Remarks: If the Show Clock command and the Show DTI-Clock command
time/date values are different and the unit is not in warm-up, then a "jam-sync" is
probably required (see
Related:
show DTI-clock, set clock
Level : User, Power-User and Admin
Set Clock
Use this command to provision the IMC's user-assigned date, time, leap seconds,
and local time offset.
Command Syntax:
To set the date and time for the IMC clock-

set clock date <yyyy-mm-dd> time <hh:mm:ss>
To set the local time offset for the IMC clock -

set clock offset <value>
To set the leapseconds value for the IMC clock -

set clock leapseconds <value>
Example 1:
To set the IMC clock to a date of 2010-02-12 and time of 11:23:44 -
097-93100-01 Revision C – February, 2010
Appendix B Command Descriptions and Communications Interface
Sync TOD-Source command).
- 2010-01-13
- 06:47:46
- +00:00
- 9:43
- 14
TimeCreator 1000 User's Guide 193
CLI Commands