Sony DVS-9000 User Manual page 95

With ccp-8000 series center control panel
Hide thumbs Also See for DVS-9000:
Table of Contents

Advertisement

• While this button is held down, you
can select a key source with the
cross-point buttons for the key bus.
• If you press this button twice in rapid
succession, the key bus selection
button [KEY3] in the cross-point
control block lights, and a key 3 key
bus cross-point can be selected.
• If you press this button, while
holding down [TRANS RATE]
button in the numeric keypad control
block, you can set the independent
key transition rate on the control
block.
b Independent key transition
execution section
KEY3 ON button: This inserts or deletes
key 3 instantaneously. When key 3 is
present in the final program output
from the switcher, this lights red, and
otherwise lights amber.
TAKE button: This carries out an auto
transition on key 3.
c K-SS (key snapshot) button
This enables key snapshot mode. In key
snapshot mode, it is possible to save and
recall key snapshots.
d Key source name display/key
snapshot buttons
These show the signal name of the key fill
selected for key 3 and the transition rate on
two buttons. In key snapshot mode, these
correspond to registers 1 and 2 for key 3;
press to save or recall a key snapshot.
To save a key snapshot, with the [K-SS]
button lit amber, hold down [SHIFT] button
and press one of the key snapshot buttons.
This saves a key snapshot in the button you
pressed, which lights yellow.
Names and Functions of Parts of the Control Panel
95

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dvs-9000sf

Table of Contents