Editing Keyboard Settings - Sony DVS-9000 User Manual

DME override
1
2
Enabling or disabling control from System Manager
By installing the BZPS-8000 System Management Software (System
Manager), you can use a computer connected on a network for management of
some switcher data and control operations.
To enable or disable this function, use the following procedure.
1
2

Editing Keyboard Settings

Note
The following operations are only possible when a license for the BZS-8050
Editing Control Software is activated. For details of license registration, see
"Installation and Device Setup (Install/Unit Config Menu)" in Chapter 18
(Volume 3).
410
Misc Menu Operations
In the menu control block, press the top menu selection button [MISC],
then select VF1 'Enable' and HF1 'Port Enable.'
The Misc >Enable >Port Enable menu appears.
In the <DME Override> group, select the DME override mode.
DME Override: When a switcher snapshot or effect using a DME is
recalled, forcibly select the DME that was used when saving.
On Air Protect: The operation is the same as the DME override function,
except that a DME being used by an M/E bank or P/P bank that is on
air will not be forcibly selected.
Note
If effects using the same DME channel are selected simultaneously in two
or more regions, the DME is selected with the order of precedence P/P >M/
E1 >M/E2 >M/E3.
In the menu control block, press the top menu selection button [MISC],
then select VF1 'Enable' and HF1 'Port Enable.'
The Misc >Enable >Port Enable menu appears.
Press [System Manager].
Each time you press the button toggles between enable and disable.