Sony DVS-9000 User Manual page 654

Combinations of Ch2, Ch3, and Ch4
Upper side: Ch2 image
Side V: Ch3 image
Side H: Ch4 image
You can adjust the height of the brick, the overlap between the three images
and the way to insert the side images.
Applying the Brick effect
1
2
3
4
654
Global Effect Operations
In the Global Effect >Ch1 - Ch4 menu, select HF2 'Brick.'
The Brick menu appears.
Press [Brick], turning it on.
The Brick effect is enabled, and a rectangular parallelepiped (brick)
showing the images of three channels appears. You can use the knobs to
adjust parameters for the height of the brick and the overlap between the
three images.
Notes
• When the Brick effect is enabled, the z-axis position of the front image
in the source coordinate frame is shifted by the amount of half the height.
Therefore, the image is somewhat magnified.
• The flex shadow function cannot be enabled when Brick is enabled.
However, the flex shadow function is not supported on the MVE-8000A.
Set the parameters.
Knob Parameter
1 Height
2 Front Overlap
3 Side H Overlap
4 Side V Overlap
Specify the way to insert the side images when the height is changed by
pressing one of the following buttons in the <Side V> group or the <Side
H> group.
Crop: Crop the parts that do not fit into the side without shrinking the
picture. You can set the following parameters.
The valid ranges of the parameter values depend on the aspect ratio
(4:3/16:9) selected in the system, as follows.
Adjustment Setting values
Height of brick 0.00 to 8.00
Front overlap –100.00 to +100.00
Side H overlap –100.00 to +100.00
Side V overlap –100.00 to +100.00