Sony DVS-9000 User Manual page 874

3
4
5
Notes
• You can only execute one macro at a time.
• During macro execution, if you recall the same register again, this stops the
874
Macro Operations in the Multifunction Flexi Pad Control Block
Press the [DRCT MODE] button, to switch to the direct recall mode in
which a macro can be recalled with the buttons in the memory recall
section.
The button indications in the memory recall section change as shown in the
following illustration.
Use one of the following operations to select the bank.
To select bank 0: Press the [BANK0] button.
To select bank 1: Press the [BANK1] button.
To select any of banks 0 to 9: Press the [BANK SEL] button, then press
the desired bank button (any of [0] to [9]).
This selects the bank, and the buttons in the memory recall section show
the macro register state as follows.
Lit yellow: Last recalled register
Lit orange: Register holding macro data
Off: Empty register
Press the button for the number of the register to be recalled.
The button you pressed lights yellow, and the macro held in the
corresponding register is recalled and executed.
The button you pressed flashes yellow as the macro execution starts, and
returns to constantly lit yellow when the execution ends.
The alphanumeric display shows the numbers of the selected bank and
register.
executing macro.