Signal Assignment And Selection - Sony DVS-9000 User Manual

Signal Assignment and Selection

Assigning signals to buttons
Each of the 32 cross-point buttons and reentry buttons has a corresponding
button number, to which you assign a signal.
In addition to the signals input to the PRIMARY INPUTS 1 to 80 connectors
(1 to 34 connectors for the MVS-8000SF/8000ASF/8000GSF) on the rear
panel of the switcher, you can also select signals generated within the switcher.
Each button has assigned to it a video signal and a key signal, forming a pair.
You can set these video and key combinations in a Setup menu.
For details of Setup menu operations, see "Cross-Point Settings (Xpt Assign
Menu)" in Chapter 19 (Volume 3).
Cross-point button control block button numbers
1, 2, 3, 4, .......
32, 33, 34, 35, .......
On each M/E bank and the PGM/PST bank, each cross-point button and reentry
button has two button numbers, and you use the shift button to switch between
these numbers.
In the case of a 32-button layout, the button numbers are as follows.
Button
From the left end to the 31st
button
Reentry buttons
Switching button numbers
The rightmost (32nd) button functions as a shift button.
146
Signal Selection
(first button numbers)
(second button numbers)
Cross-point control block button numbers
Number when the shift
button is not pressed
1 to 31
121 to 123
Shift button
M/E M/E
1 2
M/E M/E
1 2
SHIFT
M/E M/E
1 2
M/E M/E
1 2
....... 29, 30, 31 121 123
....... 60, 61, 62 125 127
Shift button
Number when the shift
button is pressed
32 to 62
125 to 127
M/E XPT
DSK3
3 HOLD
M/E XPT
KSK4
3 HOLD
MCRO MCRO
ENBL ASGN
M/E
XPT AUTO
3 HOLD RUN
M/E XPT
UTIL
3
HOLD