Sony DVS-9000 User Manual page 628

4
5
6
628
DME Special Effect Operations
In the <Surface Select> group, select the state of the surface struck by the
light.
Flat: The image surface is unchanged, causing the selected light source to
appear as the effect.
Texture: A texture appears on the surface of the image.
Non Linear: The Spotlighting effect is applied to an area to which a DME
nonlinear effect is applied.
Notes
• The BZS-9471 Texture Lighting Software (for BKDS-9470) or BZDM-
9050 Texture Lighting Software (for MVE-9000) is required to enable
Texture or Non Linear.
An install key must be entered to use the software (For details, see
"Installation and Device Setup (Install/Unit Config Menu)" in Chapter
18 (Volume 3).)
• The Spotlighting Non Linear setting is effective for the following
nonlinear effects. For any other nonlinear effect, the result of selecting
the Non Linear setting is the same as selecting Flat.
Wave, Mosaic Glass, Flag, Ripple, Lens, Panarama, Page Turn, Roll.
If you selected Texture or Non Linear in step 4, set the following
parameters.
Parameters when you selected Texture
Knob Parameter Adjustment
1 X Movement in X-axis direction
2 Y Movement in Y-axis direction
3 Size X Image size in X-axis direction
4 Size Y Image size in Y-axis direction
5 Amp Emphasize bumps and
depressions
a) Minus moves left, plus moves right.
b) Minus moves down, plus moves up.
c) Plus emphasizes bumps in texture, minus emphasizes depressions. 0.00 is a flat surface.
Parameters when you selected Non Linear
Knob Parameter Adjustment
5 Amp Distance of light
a) Light appears from Z direction. At –100.00 the light goes deepest, at +100.00 the whole
image is lit like a flat effect.
If you selected Texture in step 4, select the pattern as explained in the next
section "To select a texture pattern."
Setting values
a)
–8.00 to +8.00
b)
–6.00 to +6.00
0.50 to 16.00
0.50 to 16.00
c)
–100.00 to +100.00
Setting values
a)
–100.00 to +100.00