Dme Wipe Snapshots; Dme Wipe Snapshot Operations With The Flexi Pad - Sony DVS-9000 User Manual

With ccp-8000 series center control panel

Hide thumbs Also See for DVS-9000:

Table of Contents

DME Wipe Snapshots

You can snapshot and save a DME wipe pattern together with the current

settings of its modifiers and pattern limit in a dedicated register for recall when

There are 10 DME wipe snapshot registers for each of the M/E and P/P banks.

To save and recall these registers, use the Flexi Pad control block, the

Multifunction Flexi Pad block in each switcher bank or the Menu control

In the case of a simple transition system, there are eight DME wipe snapshot

registers for each switcher bank.

To carry out DME wipe snapshot operations, use the Flexi Pad control block.

You can save, recall and delete DME wipe snapshots using the procedures

similar to the procedures for wipe snapshot operations. In DME wipe snapshot

operations, use the [DME] button instead of the [WIPE] button used in wipe

snapshot operations.

Selecting a DME wipe pattern in the Flexi Pad control block

In the standard type Flexi Pad control block, enter a four-digit pattern number,

using the [DME] button.

For details, see "Flexi Pad Control Block (Standard Type)" (page 62).

• You cannot select a DME wipe pattern in the simple type Flexi Pad control

• A button in the memory recall section in which a DME wipe snapshot is

• In a simple type Flexi Pad control block, it is not possible to delete a DME

For details of the operating procedures, see "Wipe Snapshots" (page 298).

saved shows the pattern, and lights yellow.

For a user-programmable DME, the register number (see page 340) appears.

Depending on the setting of the Setup menu (see "Operation Settings

(Operation Menu)" in Chapter 19 (Volume 3)), you can also display a

wipe snapshot.