Separate Sides Settings - Sony DVS-9000 User Manual

Selecting the signal to insert in the background
When using the BKDS-9470 or MVE-9000, you can select the signal to insert
in the background.
With [Bkgd] set on, use the following procedure.
1
In the <Bkgd Fill> group, select one of the following.
Flat Color: single color
Mix Color: mix color signal set in the Color Mix menu (see page 559)
Ext Video: an external video signal input to the Ext IN connector
Notes
• "Mix Color"or "Ext Video" can only be applied to one of the
background, flex shadow (see page 548), trail (see page 611), and wind
(see page 619) effects.
If you select "Mix Color" or "Ext Video" in one of these settings, a
selection of "Mix Color" or "Ext Video" in any of the other effects is
disabled, and "Flat Color" is selected in its place.
• When executing combining four channels of DME images, "Mix Color"
and "Ext Video" cannot be selected.
2
Only if Flat Color is selected in step 1, adjust the following parameters.
Knob
1
2
3

Separate Sides Settings

Applies separate video signals and key signals to the front and back of the
image.
Applying the Separate Sides effect
1
In the DME menu, select VF6 'Input/Output' and HF2 'Video/Key.'
The Video/Key menu appears.
2
Press [Separate Side], turning it on.
The Separate Sides effect is enabled. If the video and key signals currently
being output to the monitor are the front side, you can select the front
Parameter Adjustment
Luminance Luminance
Saturation Saturation
Hue Hue
Setting values
0.00 to 100.00
0.00 to 100.00
359.99 to 0.00
DME Special Effect Operations
637