SHARP SERVICE MANUAL JX8200SM [8] ADJUSTMENTS
c. Starting procedure with the copied flash memory
1
Remove the IDT/Sim ROM from IC22, IC23.
2
Set PPOS, PCL ROM to IC22, IC23.
3
Set the flash memory jumpers as shown below.
J401: 1-2
J404: 2-3
4
Turn on the power and check that the operation is performed
normally.
B. ICU PWB setting
(1) ICU PWB short pin (JP1) setting
Operation
JP1 state
Boot from Flash Memory
OPEN
Boot from PROM
SHORT
J402: 2-3
J403: 2-3
NOTE
Japan specifications
EX specifications
8 – 15