Sharp JX-8200 Service Manual page 189

SHARP SERVICE MANUAL JX8200SM [13] ELECTRICAL SECTION
b. All PJL commands supported and their parameter setting range
The following Table shows all the PJL commands (19 commands) used for PJL support, their functions and parameter setting ranges.
(PJL commands and their functions)
Command Name
Kernel Commands UEL(Universal Exit Language)
COMMENT
ENTER
Job JOB
Separation EOJ
Commands
Environment DEFAULT
Commands
SET
INITIALIZE
RESET
Status INQUIRE
Readback DINQUIRE
Commands ECHO
INFO
USTATUS
USTATUSOFF
Device RDYMSG
Attendance OPMSG
Commands STMSG
CLEAR
(Each command parameter and its setting range)
Parameter which is not supported is struck out.
Parameter which must be created newly for Color Laser Printer and setting range which is different from HP original are painted gray.
Commands and parameters which are not marked comply with HP originals. Added command and parameter must operate as described.
Command
UEL None
COMMENT Remarks
(Comment sentence)
ENTER LANGUAGE
(Personality)
JOB NAME
START
END
EOJ NAME
Must be inserted in the beginning mode and end, when exiting from current printer
language for controlling by PJL.
Gives comment.
Selects printer language for processing job.
Informs printer of the beginning of job.
Informs printer of the job end. Resets page count.
Default setting (to EEPROM).
User Default Environment
(Temporary) setting during PJL job. PJL Current Environment
PJL Currnt Environment
Resets current value to factory default value (INITIALIZE).
Resets current value to default value.
Requests the sending of current value (PJL Current Environment).
Request the sending of information of default value (User Default Environment).
Used to synchronize host and printer. It clarifies time, and which job is printing
Requests the sending of printer's specific information (model No., configuration,
memory amount, etc.)
Sets if unsolicited message (error, etc.) is automatically returned or not.
Deletes the request for unsolicited message.
Changes control panel message. Printer remains online.
Changes control panel message, and sets printer offline.
Shows which key operator pressed to set printer online
Performs the same operation as when the key is pressed on the control panel.
Parameter
ASCII CODE 33 to 255
and <WS>
PCL
PostScript
ASCII CODE 33 to 255, (Job Name)
<SP>, <HT>
1 to 2147483647 (Page where job begins)
1 to 2147483647 (Page where job ends)
ASCII CODE 33 to 255
<SP>, <HT>
13 – 30
Command Function
Range