Table of Contents
Advertisement
Accessing the Layer 3 Services Module for the First Time
Purpose
Step 8
Router (config-if) #exit
Step 9
Router (config) #line vty line-number
Step 10
Router (config-line)
#password password
Step 11
Router (config-line) #end
Step 12
Router #copy running-config
startup-config
This example shows you how to assign an IP address to the Catalyst 4000 Layer 3 Services module
10/100 management port:
Router#configure terminal
Enter configuration commands, one per line.
Router(config)# interface F1
Router(config-if)# ip address 131.108.1.27 255.255.255.0
Router(config-if)# no shutdown
Router(config-if)# exit
Router(config)# line vty 0
Router(config-line)#password 7 Cisco
Router(config-line)# end
Router#copy running-config
By default, the 10/100 management interface does not route data traffic. We recommend
Note
that you not try to override this default configuration.
You can also download images and configuration files to the Catalyst 4000 Layer 3 Services module
through one of the Gigabit Ethernet routing ports. If you choose to manage the Layer 3 Services module
through a Gigabit Ethernet routing port, any IP address assigned to the corresponding interface can be
used for network management purposes when the port is up.
SNMP Network Management
The supervisor engine reports one IP address assigned to the Layer 3 Services module that can be used
for network management through the Cisco Stack MIB. If you are using CiscoView to manage your
Catalyst 4000 switch, you can also manage the Catalyst 4000 Layer 3 Services module with this
software.
If the 10/100 management interface is up and an IP address has been configured, the Layer 3 Services
module selects the IP address assigned to the 10/100 management port. If the management port is down
or an IP address has not been configured, the module randomly selects an IP address that has been
assigned to one of the Gigabit Ethernet ports or port channels as the network management IP address,
provided the interface associated with this IP address is up at the time of selection.
If the selected network management IP address is removed or the interface or subinterface associated
with this IP address is shut down, the Layer 3 Services module selects another IP address as a
replacement.
Installation and Configuration Note for the Catalyst 4000 Layer 3 Services Module
30
Command
Return to global configuration mode.
Enter line configuration mode for virtual terminal
connections. Commands entered in this mode control the
operation of Telnet sessions to the Catalyst 4000 Layer 3
Services module.
Enter a password for Telnet sessions.
Return to privileged EXEC mode.
Save your configuration changes to NVRAM.
End with CNTL/Z.
78-10164-03
Advertisement
Table of Contents
