Omron EQ100-E User Manual page 96

7. EQ100 Settings
Shown below are connection devices that must be registered before registration of
measurement devices.
Measurement Device
Wireless Device Thermo-Humidity
Sensor (WZ-STH01)
Wireless Device Light Intensity
Sensor (WZ-SL01)
Wireless Device Thermo-Humidity
Light Intensity Sensor
(WZ-STHL01)
Wireless Device CO
2
(WZ-SCD01)
Wireless Unit Slave
(Pulse Count)(WZ-SP01)
RS-485-Connected Measurement
Device
(KM20-B40-FLK)
(KM100-T-FLK)
(KM50--FLK)
(KM1-PMU1A-FLK)
(KM1-PMU2A-FLK)
(KM1-EMU8A-FLK)
(KE1-CTD8E-FLK)
(ZN-PD-S)
(K3GN--FLK)
(E5C)
■Setup Steps
1) In the setting menu, click [Connection Device Registration].
Precautions
- To register a wireless unit slave (CompoWay/F) (WZ-SRS01), first add the wireless master
unit as a destination. If a wireless master device is not registered, the wireless master device
cannot be configured in a selection of destination to connect even if you try to register a
wireless/RS-485 converter (WZ-SRS01).
2) Click [Add].
Required Connection
Device
Wireless Unit Master
(WZ-MLAN01)
Sensor
Wireless Unit Master
(WZ-MLAN01)
Wireless Unit Slave
(CompoWay/F)
(WZ-SRS01)
Remarks
RS-485 connection of the air
particle sensor (ZN-PD-S)
is available only through a
wireless slave unit
(CompoWay/F) (WZ-SRS01).
Note that a daisy chain
connection with other
RS-485-connected
measurement device is not
available. For details, refer to
the user's manual of the air
particle sensor.
7-7